The new i-box® by Eurotec provides a monitoring solution in applications where there is very little space around the pneumatic part turn actuator. With its external dimensions of 115x65x55mm, it is extremely compact and space-saving. The i-box® is mounted directly on the pneumatic part turn actuator with its own special fastening system. It can be mounted on every usual actuator hole spacing and actuator shaft height. The i-box has a visible OPEN-CLOSED position indication with an electronic feedback and the housing is leak proof to a measure of IP67 according to DIN EN 60529. Despite its very small design, the i-box® is very flexible and provides the user enough space for a modest connection. The large cable gland M20 allows the insertion of cables with an external diameter of 6-12mm and the terminal block is inside the housing as high as possible to guarantee good accessibility. The tiny housing can accommodate mechanical change-over switches as well as proximity switches with 2-wire or 3-wire technique and it provides the possibility to connect one or two solenoid coils. The cams for the activation of the built-in micro switches or proximity sensors can be adjusted on any required swivel range and the switch box can be mounted on the actuator in only two steps.