Upgraded ECOTROL 8C 4.0 process control valve

Version W4 of the ECOTROL® 8C series, which resulted from a technical revision focused on product quality, flow capacity and life cycle costs, has been available since the beginning of 2015.

It is characterised by many technical improvements. All housings up to DN 100 (4”) in nominal pressure PN 16, PN 40 and ANSI Class 150 and 300 as well as the associated bonnets are manufactured in the standard materials 1.0619 (A216WCB) and 1.4408 (A351CF8M) as investment castings in the lost-wax process. This results in an improved surface finish. Beyond that, the wall thickness required for casting is thinner, especially with small nominal sizes, which leads to a considerable reduction in the weight of the valve. The standard material of stainless steel housings has been changed as a matter of principle to 1.4408 (A351CF8M); this enables the delivery of valves for the temperature range down to -196 °C at short notice. The trims have been optimised with regard to seat diameter, flow coefficient and characteristic; the valve plugs and stems are now manufactured from an inexpensive friction-welding blank. The actuator yoke was changed from nodular cast iron GGG 40.3 to cast steel that is resistant to low temperatures. The actuator type 812 is thus usable in principle even where there are requirements for earthquake protection as well as at temperatures down to -40 °C.

Previous articleRCP wins six -figure contract by Awilco Drilling
Next articleEmerson acquires Energy Solutions International